|
|
Kia Sportage>> Brake system
Brake system
Specifications
|
|
Separate characteristics are resulted also in the text of the head and in case of compulsion of their performance are allocated by a bold type. |
The general data
System type
|
|
Hydraulic, two-planimetric, with the vacuum amplifier and a dynamic regulator brake force |
|
|
Hydraulic, two-planimetric, with the vacuum amplifier and elektronno-hydraulic adjustment of brake forces |
Type and volume of a hydraulic liquid
|
Specifications to the Head Current leaving and service see |
Brake mechanisms
|
Forward wheels |
| Type |
Disk, ventilated |
| Thickness of frictional overlays колодок, mm |
|
|
11 |
Limiting admissible value
|
2.0 |
| Thickness of brake disks, mm |
|
|
24.0 |
Limiting admissible value
|
22.4 |
| Limiting admissible size of lateral palpation, mm |
0.1 |
|
Back wheels |
| Type |
The drum-type |
| The maximum admissible diameter of a brake drum, mm |
251.2 |
| The minimum admissible thickness of frictional overlays of boots, mm |
1.5 |
| Limiting admissible size люфта landings башмачных assemblages in drums (see Has undressed Service of drum-type brake mechanisms of back wheels), mm |
Data are absent |
Lay brake
| Drive type |
Manual, тросовый with an exit on brake mechanisms of back wheels |
| Quantity of clicks of a ratchet at raising приводного the lever with effort 10 кГс |
6 8 |
Regulator of brake forces
| Target pressure of a regulator (approximately), кГс/см2 |
At entrance pressure 32 кГс/см2
|
30 32 |
At entrance pressure 100 кГс/см2
|
52 63 |
Pedal of a foot brake
| Height in the released condition (see an illustration), mm |
226 231 |
| Free wheeling size (see an illustration), mm |
4 7 |
| Height in the squeezed out position (see an illustration), mm |
117 |
The vacuum amplifier of brakes
The Section Check of serviceability of functioning of the vacuum amplifier of brakes see.
ABS/EBD
| Size of working backlashes of wheel gauges ABS, mm |
|
|
|
0.3 1.0 |
|
|
0.5 1.0 |
| Resistance of wheel gauges, Ohm |
|
|
1385 110 |
|
|
1000 50 |
Codes of malfunction ABS/EBD
|
DTC
|
Possible source of refusal
|
The possible reason |
| С1101 |
Excessively (> 17 pressure of the battery |
Corresponding electroconducting is faulty;
It is faulty HECU |
| С1102 |
There is not enough (<9.4 pressure of the battery | Corresponding electroconducting is faulty;
It is faulty HECU |
| С1200, С1203, С1206 |
Chain corresponding (left forward/right forward/back) the wheel gauge |
Breakage, or short circuit on weight;
The gauge is faulty;
It is faulty HECU |
| С1201, С1204, С1207 |
Non-standard signal corresponding (left forward/right forward/back) the wheel gauge |
It is incorrectly established, or the corresponding gauge is faulty;
The gauge rotor, or the wheel bearing (forward wheels) is faulty;
It is faulty HECU |
| С1202, С1205, С1208 |
There is no signal from corresponding (left forward/right forward/back) the wheel gauge |
It is incorrectly established, or the corresponding gauge is faulty;
The gauge rotor is faulty;
It is faulty HECU |
| С1274, С1275 |
Alarm line of the gauge of overloads (G) |
Electroconducting breakage between gauge G and HECU;
Gauge G is faulty;
It is faulty HECU |
| С1604 |
Chain HECU |
Infringement on a chain site between HECU and э/м the valve;
It is faulty HECU |
| С2112 |
The klapannoe relay or safety lock |
It is faulty клапанное the relay;
Connecting electroconducting is faulty;
It is faulty HECU;
The hydromodulator is faulty |
| С2402 |
Electromotor chain |
Breakage or short circuit in a chain of the electromotor or its relay (including a safety lock);
It is faulty HECU;
The hydromodulator is faulty |
Efforts of a tightening of carving connections, Hм
|
|
Efforts of a tightening of separate elements of fixture can be resulted directly in the text of sections where they are allocated by a bold type. |
| Wheel bolts |
98 |
| Counternut D of a rod of a pusher of the vacuum amplifier (see an illustration an illustration) |
23.5 34.3 |
| Counternut In the gauge-switch of stoplights (see an illustration) |
13.7 17.7 |
| Axial nuts of a pedal of a foot brake |
27 |
| Nuts of fastening of a basic arm of a regulator of brake forces |
9.8 16 |
| Bolt of fastening of a regulator of brake forces |
22.6 42.2 |
| Nuts штуцерных sockets of a regulator of brake forces |
12.8 21.6 |
| Lock bolt ГТЦ |
2.0 2.5 |
| The screw of fastening of the tank of a brake liquid |
1.0 1.5 |
| Nuts штуцерных sockets ГТЦ |
13 22 |
| Nuts of fastening of the vacuum amplifier of brakes |
16 23 |
| Nuts штуцерных sockets of a joint of flexible hoses with tubes of brake lines |
8 12 |
| Bolts of fastening of supports of brake mechanisms of forward wheels |
88 108 |
| Hollow bolts штуцерных connections of supports |
22 29 |
| Directing bolts of supports of brake mechanisms of forward wheels |
22 34 |
| Bolts of fastening of wheel cylinders to boards of brake mechanisms of back wheels |
8 18 |
| Nuts of fastening of boards of brake mechanisms of back wheels |
98 |
| Bolts of fastening ECU to HCU |
|
|
1.3 1.4 |
|
|
1.7 1.9 |
| Adjusting pin HECU |
5.8 7.2 |
| Nuts штуцерных sockets HCU |
9.4 15.9 |
| Bolts of fastening of wheel gauges |
9.5 |
|
|