KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
   The general information
   Coupling
      The general data
      Check and updating of level of a hydraulic liquid
      Check and adjustment of a pedal of coupling
      Removal and installation of a pedal of coupling
      Removal, service and installation of the main cylinder of a drive of deenergizing of coupling
      Removal, service and installation of the executive cylinder of a drive of deenergizing of coupling
      Removal, check of a condition and installation of components of coupling
   Distributing box
   Kardannye shaft
   Bridges
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections

Kia Sportage>> Transmissionnaja line>> Coupling>> Removal and installation of a pedal of coupling

Removal and installation of a pedal of coupling

Details of installation of a pedal of coupling

1, 4, 11 — Nuts
2, 6 — Bolts
3 — The Returnable spring
4 — The Flat washer
7 — The Remote plug
8 — Axial plugs
9 — the Clamp (is subject to replacement without fail)

10 — the Finger
12 — the Pusher
13 — the Cutting head
14 — the Emphasis
15 — the Pedal
16 — the Overlay колодки


 PERFORMANCE ORDER

    Take a clamp and a finger of fastening of a pusher. Disconnect a returnable spring. Give a fixing nut, remove a washer and take an axial bolt. Take remote and two axial plugs. Estimate degree of deterioration of axial plugs and an overlay колодки, whether check up will drive the lever of a pedal and whether ослабла a returnable spring. Replace defective components. Installation is made in an order, the return to an order of dismantle of components, - axial and remote plugs before landing grease литиевой with greasing (NGLI № 2). Track observance of requirements of Specifications of Head Transmissionnaja a line to efforts of a tightening of carving fixture. In summary do not forget to adjust a pedal free wheeling (the Section Check and adjustment of a pedal of coupling see).