KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
   Security measures and the general rules accepted at service of components of fuel paths of internal combustion engines
   The power supply system of petrol engines
      The general information
      Check and adjustment of quantity of turns of a single course/moment of ignition/concentration WITH
      Sbrasyvanie pressure in fuel system of the petrol engine, filling of a fuel path
      Power supply system checks
      Removal and installation of components of an inlet air path
      Removal and installation of a pedal of gas, adjustment of a cable of a drive throttle заслонки
      Removal and installation of a fuel tank
      Removal and installation of the fuel pump
      Removal and installation of the gauge of a stock of fuel
      Removal and installation kontrolno-zapornogo the valve
      Removal and installation of submitting and returnable lines of a fuel path
      Removal and installation of a jellied mouth of a fuel tank and separator of fuel evaporations
      Removal and installation of the filter of thin clearing of a fuel path
      Removal and installation of a regulator of pressure of fuel
      Removal and installation топливораспределительной highways
      Removal and installation of fuel injectors
   The power supply system of diesel engines
   Control systems of the engine and decrease in toxicity of the fulfilled gases
   System of release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections




сайт Kia Sportage>> Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases>> The power supply system of petrol engines>> Sbrasyvanie pressure in fuel system of the petrol engine, filling of a fuel path

Sbrasyvanie pressure in fuel system of the petrol engine, filling of a fuel path

Before starting to work, familiarise with materials of Section of the Security measure and the general rules accepted at service of components of fuel paths of internal combustion engines.

Sbrasyvanie pressure

During performance of described procedure only superfluous pressure in a power supply system path is dumped, thus continuing will fill топливопроводы fuel to be under some residual superfluous pressure, - before a detachment of fuel lines accept corresponding safety measures!


 PERFORMANCE ORDER

  1. Start the engine.
  1. Lift a back seat, unbend the rectangular valve of the panel of a carpet covering and disunite a socket (2) electroconductings of the fuel pump (1) in a service window of the panel of a floor.
  1. Wait spontaneous останова the engine, then switch off ignition and restore initial connection of electroconducting.
  2. Lower a back seat in regular position.

Path filling

 PERFORMANCE ORDER

  1. After performance of procedures of service of the car, connected with necessity сбрасывания pressure in the power supply system, before the first start for the purpose of prevention of necessity excessively long проворачивания the engine it is necessary to make preliminary filling of a fuel path.
  1. By means of a suitable crosspiece close among themselves plugs 1 (FUEL PUMP) and 5 (In +) diagnostic socket DLC, - the socket is located in an impellent compartment, is fixed on a casing of an air cleaner and equipped by a folding protective cover.
  1. Make 10-second (no more) inclusion of ignition for the purpose of short-term activation of the fuel pump, - inclusion of ignition more than for 10 seconds is interfaced to risk of a dangerous overheat of a crosspiece.
  2. Switch off ignition and remove a crosspiece. Examine components of a fuel path on presence of signs of development of leaks. In case of need make corresponding corrections.