Security measures and the general rules accepted at service of components of fuel paths of internal combustion engines

At service of components of a fuel path it is necessary to adhere to following general rules:

Do not come nearer to a place of performance of works with open fire, do not smoke and do not include any heating devices! Always keep in readiness the fire extinguisher; Fuel evaporations are toxic, - make power supply system service in well ventilated premise; Remember that the fuel path of system of injection constantly is under pressure, - at отпускании штуцерных sockets fuel can be pulled out from a line under pressure! Do not forget to put on the goggles, the spilt fuel immediately collect rags; Keep in mind that pressure of fuel at an exit in the diesel engine makes of atomizers of an order 1100 атм, - do not suppose hit of any parts of a body under a fuel stream; Collars of tape and tightening type can be applied to fastening шланговых connections of a fuel path. After a detachment of hoses it is necessary to replace tightening collars tape or worm. Fixing of locks of some collars demands application of special adaptations, - consult with experts firm HUNDRED KIA. Before to remove any components of a fuel path carefully wipe their surfaces in places of interface to the purpose of prevention of internal pollution of system; The removed components stack on a pure lining and cover with polyethylene, a paper, or НЕВОРСЯЩЕЙСЯ rags; Do not forget to cork the open ends disunited штуцерных sockets of a fuel path, whenever possible using for this purpose special заглушки; Special attention give to cleanliness observance, - carefully wipe and degrease all established components, replaceable details take from packing only directly ahead of installation; Avoid application of compressed air at the opened fuel system, whenever possible try not to move the car; Do not apply to hermetic sealing of joints of components hermetics containing silicone, - hit in the engine of particles of poorly combustible silicone is interfaced to risk of failure of ljambda-probes; Before removal of a fuel tank merge from it all fuel, - in case of need take advantage for fuel pumping out by the special pump; Before a detachment of assembly tapes of fastening of a fuel tank at removal of the last prop up it from below тележечным a jack through a wooden lining; Remember that the emptied fuel tank is potentially explosive and before recycling should be without fail cut on a part, - take measures against искрообразования at use of the cutting tool; After installation of a fuel tank on the car start the engine and check up tightness of corresponding connections.