|
Kia Sportage>> Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases>> The power supply system of petrol engines>> Removal and installation топливораспределительной highways
Removal and installation топливораспределительной highways
Installation details топливораспределительной highways
|
- Dump pressure in the power supply system (Razdel Sbrasyvanie of pressure in fuel system of the petrol engine, filling of a fuel path see).
- Merge cooling liquid (Current leaving and service see the Head).
- Disconnect a negative wire from the battery.
- Turn out two bolts of an air line of an inlet air path.
- Release a fastening collar шланговой air line sections to inlet section of the case of a throttle.
- Remove four ventilating hoses connected in an air line.
- Disconnect electroconducting from gauge MAF.
- Turn out bolts of fastening of assemblage of gauge MAF.
- Release a collar of fastening of an air line to air cleaner assemblage.
- Turn out a bolt of fastening of a basic arm of an air line.
- Turn out bolts of fastening of a basic arm of a cable of a drive throttle заслонок.
- Disconnect a cable of a drive throttle заслонок.
- Remove the vacuum hose going from the inlet pipeline to a vacuum tube.
- Disconnect electroconducting from TPS and valve IAC.
- Disconnect two hoses охладительного a path from the throttle case.
- Release a fixing collar and disconnect a hose of assemblage of valve IAC.
- Release a collar and disconnect a hose from воздухораспределителя.
- Release collars and disconnect from воздухораспределителя vacuum hoses of the brake amplifier and темпостата.
- Turn out two fixing bolts and remove воздухораспределителя a basic arm.
- Turn out the bottom bolt of a basic arm of valve IAC.
- Turn out two top bolts of a basic arm of the inlet pipeline.
- Hang out the car over the earth.
- Turn out the bottom bolts of a basic arm of the inlet pipeline.
- Lower the car on the earth.
- Disconnect from a knee an inlet hose of a heater.
- Disconnect a vacuum hose from a vacuum tube.
- Give three bolts with nuts and remove воздухораспределитель.
- Disconnect топливопровод from a pressure regulator.
- Disconnect submitting hose from топливораспределительной highways.
- Turn out two bolts of fastening of a highway.
- Remove clamps of fastening of injectors and remove топливораспределительную a highway.
- Remove two инжекторных an insulator (see Has undressed Removal and installation of fuel injectors).
- Remove демпфер pressure pulsations.
- Remove a regulator of pressure of fuel (see Has undressed Removal and installation of a regulator of pressure of fuel).
- Carefully smooth out all interfaced surfaces.
- Installation is made upside-down. Do not forget to adjust a cable of a drive throttle заслонки (see Has undressed Removal and installation of a pedal of gas, adjustment of a cable of a drive throttle заслонки).
- In summary fill cooling system, start the engine and check up it on presence of signs of leaks of corresponding working liquids.
|
|
|
|