KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
   The general information
   Coupling
   Distributing box
      The general data
      Removal and installation of the lever of switching of modes of a distributing box
      Removal and installation of assemblage of a drive of a speedometer
      Replacement of epiploons of target shaft
      Removal and installation of a distributing box
   Kardannye shaft
   Bridges
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections




canada online shopping Kia Sportage>> Transmissionnaja line>> Distributing box>> Removal and installation of a distributing box

Removal and installation of a distributing box

Depending on specificity of prospective procedures of service the distributing box can act in film both in gathering with transmission, and in an individual order. The description of procedure of removal of a distributing box in gathering with transmission is resulted in Heads the Five-step manual box of a gear change and Automatic transmission.


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove levers of switching of RKPP/SELECTOR AT (the Five-step manual box of a gear change or Automatic transmission accordingly see the Head) and a distributing box (see Has undressed Removal and installation of the lever of switching of modes of a distributing box).
  3. Merge from a distributing box oil (Current leaving and service see the Head).
  4. Remove карданные shaft (see Has undressed Removal, service and installation карданных shaft).

In order to avoid balancing infringement карданного a shaft do not disunite шлицевое a joint of its sections!

  1. Disconnect electroconducting from the gauge-switch of the alarm indicator 4WD.
  2. Disconnect electroconducting from VSS.
  3. In order to avoid damage of support of a suspension bracket of the power unit prop up transmission тележечным a jack.
  4. Turn out fixing bolts (two in a support and two in the chassis) and remove a lateral support of a suspension bracket of a distributing box.
  5. Turn out eight fixing bolts of the chassis, plus four bolts of fastening of the bottom support and remove a cross-section beam.
  6. Prop up a distributing box тележечным a jack.
  7. Turn out 10 fixing bolts and, slightly обстукивая an interfaced surface киянкой, separate a distributing box from transmission.
  8. Lower a distributing box, take it from under the car and transfer on a workbench.
  9. Installation is made upside-down, - track observance of requirements of Specifications of Head Transmissionnaja a line to efforts of a tightening of carving fixture. Special attention give to correctness of connection карданных shaft (track correctness of combination of the landing labels put in the course of dismantle).
  10. In summary fill in in a box necessary quantity of fresh oil of a demanded grade, in the correct image having modified its level (Current leaving and service see the Head).