|
|
Kia Sportage>> Transmissionnaja line>> Distributing box>> Replacement of epiploons of target shaft
Replacement of epiploons of target shaft
|
|
The order of performance of procedure is similar for both target shaft of a distributing box. |
|
|
Hang out the car over the earth.
Turn out four fixing bolts (two in a support and two in the chassis) and remove a lateral support of a suspension bracket of a distributing box.
Merge from a distributing box oil (Current leaving and service see the Head).
Having marked landing position of components (see an illustration), turn out fixing bolts and separate from a distributing box corresponding карданный a shaft, - take a shaft aside and tie up it to a cross-section beam.
|
|
In order to avoid balancing infringement карданного a shaft do not disunite шлицевое a joint of its sections! |
Having marked landing position, remove a connecting flange of a target shaft.
|
|
The nut of a forward flange is painted in silvery colour and have link sided cutting. For fastening of a back flange the nut of bronze colouring with a right-hand carving is used. |
Having hooked a suitable screw-driver, take an old epiploon.
Under catalogue number of a detail make sure of correctness of selection of a replaceable epiploon and plant it to the place of the removed.
Establish into place a connecting flange and tighten a nut of its fastening with demanded effort (111 Nanometers), - track correctness of combination of the landing labels put in the course of dismantle.
Приболтите to a flange карданный a shaft, - besides track correctness of combination of the landing labels put in the course of dismantle. Screw and tighten with demanded effort (36 Nanometers) fixing bolts.
Having replaced a sealing washer, screw into place and tighten with demanded effort (30 Nanometers) a drain stopper картера a distributing box.
Fill in in a box necessary quantity of fresh oil of a demanded grade, in the correct image having modified its level (Current leaving and service see the Head).
Replace a sealing washer screw into place and tighten with demanded effort (30 Nanometers) a jellied/control stopper.
Screw into place bolts and nuts of a lateral support of a distributing box. Tighten fixture with demanded effort (nuts: 40 Nanometers, bolts: 23 Nanometers), then lower the car on the earth.
|
|
|
|