KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
   The general information
   Coupling
   Distributing box
      The general data
      Removal and installation of the lever of switching of modes of a distributing box
      Removal and installation of assemblage of a drive of a speedometer
      Replacement of epiploons of target shaft
      Removal and installation of a distributing box
   Kardannye shaft
   Bridges
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections




price of daily cialis cheap cialis ejaculation with cialis Kia Sportage>> Transmissionnaja line>> Distributing box>> Removal and installation of the lever of switching of modes of a distributing box

Removal and installation of the lever of switching of modes of a distributing box

 PERFORMANCE ORDER

  1. Turn out two fixing screws, cock the lever of a lay brake and remove back section of the central console.
  2. Release counternuts and remove handles of levers of switching of RKPP/SELECTOR AT and a distributing box.
  3. Turn out three fixing screws, and remove forward section of the central console.
  4. Release fixing a nut/bolt, remove a fixing plate and dismantle пыльник () the lever of switching of modes of a distributing box and the lever of switching Manual transmission (on models of a corresponding complete set).
  1. Turn out fixing bolts and remove the lever (1) switchings of a distributing box. Take aside посаженый on a forward bolt a clamp of electroconducting and remove the back console.
  1. Examine the lever on presence of signs of deterioration of mobile components, deformations and other mechanical damages. Check up a condition of a spring and a sealing element. Visually estimate degree of deterioration of visible elements of a drive of switching of a distributing box. Defective components replace.
  2. Grease a landing surface of a plate of the basis of the lever with silicone hermetic and get lever assemblage on the regular place, - do not forget to plant on a forward bolt a clamp of a plait of electroconducting.
  3. The further installation is made in an order, the return to an order of dismantle of components, - track observance of requirements of Specifications of Head Transmissionnaja a line to efforts of a tightening of carving fixture.