|
Kia Sportage>> Five-step manual box of a gear change>> Removal and installation Manual transmission
Removal and installation Manual transmission
|
- Disconnect a negative wire from the battery.
- Hang out the car over the earth.
- Merge трансмиссионное oil (Current leaving and service see the Head).
|
- Disconnect back and forward (at a corresponding complete set) карданные shaft, - do not forget to mark preliminary position of a shaft concerning the connecting flange.
|
|
- Disconnect electroconducting from the gauge-switch of fires of a backing.
|
|
- At a corresponding complete set disconnect a socket of the gauge-switch of activation of an all-wheel drive mode on a distributing box.
|
|
- Disconnect electroconducting from the gauge of speed (VSS).
|
|
- Turn out fastening bolts трансмиссионной assemblages to the engine and remove растяжную a kerchief.
|
|
- Disconnect electroconducting from the gauge of position of a cranked shaft (CKP).
|
- Remove a starter (see the Head of System of an electric equipment of the engine), a basic arm of system of release of the fulfilled gases (Power supply systems see, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases) and растяжную a kerchief.
- Turn out a fixing bolt and remove a basic arm of fixing of a hose of a hydrodrive of coupling, then give bolts and dismantle the executive cylinder.
- Remove the lever of switching Manual transmission (see Has undressed Removal and installation of the lever of switching Manual transmission).
- At a corresponding complete set remove the lever of switching of a distributing box (the line see Head Transmissionnaja).
|
- Prop up a basic beam трансмиссионной assemblages тележечным a jack.
|
|
- Turn out bolts of fastening of a beam and lower last on a jack together with трансмиссионной assemblage.
|
- Turn out a bolt of fastening of a rubber pillow of a support of a suspension bracket трансмиссионной assemblages.
- At a corresponding complete set turn out fixing bolts and separate from Manual transmission a distributing box.
- Installation is made upside-down, - track observance of requirements of Specifications of the Head the Five-step manual box of a gear change to efforts of a tightening of carving fixture.
|
Before connection of a distributing box grease its interfaced surface with hermetic. At connection карданных shaft track correctness of combination of the landing labels put in the course of dismantle. |
|
|
|
|