KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
   The general information
   System of cooling of the engine
      Cooling liquid - the general data
      Replacement of a cooling liquid - broad-brush observations
      Tightness check, replacement of hoses of system of cooling
      Thermostat check
      Check of serviceability of functioning муфты couplings of the fan of system of cooling
      Washing of a path of system of cooling
      Removal and thermostat installation
      Removal, check of a condition and installation of a radiator of system of cooling, replacement радиаторных hoses
      Removal and installation of a broad tank
      Removal and installation перепускного a branch pipe охладительного a path of the petrol engine
      Replacement of the bearing of a drive of the fan of system of cooling
      Removal, installation and service of the water pump
   Systems of ventilation, heating and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections




Kia Sportage>> Systems of cooling, heating, ventilation and air conditioning>> System of cooling of the engine>> Replacement of the bearing of a drive of the fan of system of cooling

Replacement of the bearing of a drive of the fan of system of cooling

 PERFORMANCE ORDER

  1. Remove a belt of a drive of the generator.
  2. Remove крыльчатку the fan, then dismantle from a landing flange подшипниковой assemblages a pulley of a drive of the fan.
1 — Krylchatka
2 — the Pulley
  1. Release fixture and remove подшипниковую assemblage (1) from the engine block.
  1. By means of a special stripper and approaching выколотки dismantle on a press a landing flange приводного a pulley.
1 — the Press
2 — Vykolotka
  1. By means of cylindrical оправки in external diameter 20 mm выпрессуйте the bearing.
1 — the Press
2 — Vykolotka
3 — a bearing Shaft
  1. Запрессуйте a power shaft in a landing flange of a pulley, - the size выступания shaft pins over a face surface ступичной flange parts should make 2.1 mm.
1 — the Flange
2 — a bearing Shaft
3 — the Press
4 — Vykolotka
5 — the Bearing
6 — the Flange
  1. Having arranged components according to the resulted instructions, make запрессовку the new bearing in the landing nest in a basic arm.
1 — Vykolotka
2 — the Landing flange
3 — the Bearing
  1. The further installation is made in an order, the return to an order of dismantle of components, - track observance of requirements of Specifications of the Head of System of cooling, heating, ventilation and an air conditioning to efforts of a tightening of carving fixture. Do not forget to adjust effort of a tension of a belt of a drive of the generator.