KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
Brake system
Suspension bracket and steering
   The general information
   Estimation of a condition of components of a suspension bracket and steering drive
   Forward suspension bracket
   Back suspension bracket
      The general information
      Removal of air from a working path of system of hydrostrengthening of a wheel
      Check of a pressure of the steering pump
      Removal, check and installation of a steering wheel and steering column
      Removal and installation of tips of steering draughts
      Removal and installation of components of a steering drive
      Removal and installation of the steering pump
   Suspension bracket geometry
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections

Kia Sportage>> Suspension bracket and steering>> Steering>> Removal, check and installation of a steering wheel and steering column

Removal, check and installation of a steering wheel and steering column



    Tyre out the car on an equal horizontal platform with a firm covering and result forward wheels in rectilinear position. Disconnect a negative wire from the battery. Remove an overlay of a steering wheel and disunite two sockets of electroconducting of the switch of a horn. At a corresponding complete set remove from a steering wheel the module of a driver's pillow of safety (the Onboard electric equipment see the Head).
    Release a fixing nut and by means of a suitable stripper dismantle a steering wheel, - at all do not make attempt of removal of a steering wheel by постукивания a hammer on a shaft!
    Turn out fixing screws and remove the top and bottom sections of a casing of a steering column.
1 — the Top cover
2 — the Bottom cover
    Remove a cam (1) returnable switches.
    Turn out a bolt of fastening of assemblage подрулевых switches.
    Disunite four contact sockets and remove assemblage of the combined switches (1) from a steering column.
    Turn out four fixing screws (1) and remove the bottom section of furnish of the panel of devices.
    Disunite four sockets (1) electroconductings of contact group of the switch of ignition.
    Turn out two bolts of fastening of the top basic arm of a steering column.
    Give four bolts/nuts of fastening of the bottom basic arm of a steering column.
    Turn out a bolt of fastening of an intermediate shaft and remove a steering column.
    Chisel punch шлицы in срезных heads of fixing bolts and, having screwed the last a screw-driver, remove assemblage of the lock of blocking of a steering shaft.



    Examine a column on presence of signs of mechanical damages.
    Measure column total length, - demanded value makes 766.5 mm.
    Estimate a condition карданного the hinge of an intermediate shaft, - the hinge should rotate smoothly, silently and not to have люфтов.



    Establish on a steering column assemblage of the blocking lock and fix its new bolts, having tightened the last before cutting of heads.
    The further installation is made in an order, the return to an order of dismantle of components, - track observance of requirements of Specifications of the Head the Suspension bracket and a steering to efforts of a tightening of carving fixture.