|
|
|
|
KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
The general information
System of cooling of the engine
Systems of ventilation, heating and air conditioning
The general information and security measures
Diagnostics of malfunctions, check of components of system K/V
Removal and installation of assemblage of the forcing fan/evaporator, service of components
Removal and installation of assemblage of a heater, service of components
Removal and installation of lines of communication of a refrigerator path of system K/V
Removal, check and compressor K/V installation
Removal, check and installation of the fan of condenser K/V
Removal, check and condenser K/V installation
Removal, check and receiver-dehumidifier installation
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections
|
|
|
|
Kia Sportage>> Systems of cooling, heating, ventilation and air conditioning>> Systems of ventilation, heating and air conditioning>> Removal, check and installation of the fan of condenser K/V
Removal, check and installation of the fan of condenser K/V
Removal
|
|
Ventiljatornaja assemblage is located ahead of the condenser heat exchanger, at once behind a forward lattice.
Prop up wheels противооткатными boots.
Disconnect a negative wire from the battery.
Remove three clamps of fastening of the finishing panel to the top section of a forward casing.
Turn out the screw of fastening of a forward lattice to a cowl rack.
Accurately wring out four lock uvulas and remove a forward lattice.
Liberate clamps from lateral sections of a forward casing and latch them on the regular places in a forward lattice.
|
|
Disunite a socket of electroconducting of the fan of the condenser.
|
|
|
Turn out fixing bolts and remove вентиляторную assemblage.
|
|
|
Check
|
|
By means of an ohmmeter make sure available conductivity between plugs of a socket of electroconducting of the fan. If conductivity is absent, replace приводной the electromotor.
Submit on plugs of the electromotor a food 12 In, - if крыльчатка will not start to rotate, replace the electromotor.
|
|
Installation
|
|