KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
   The general information and safety measures
   Search of causes of failures of an electric equipment
   Safety locks - the general information
   Chain breakers - the general information
   The relay - the general information and check of serviceability of functioning
   Assembly blocks of safety locks/relays - the general information, removal, installation, replacement of safety locks
   System of timers and alarm gongs (ETWIS) - the general information, removal and installation of the operating module
   Check of serviceability of functioning of the switch of ignition
   Check of serviceability of functioning подрулевых switches
   Check of serviceability of functioning of operating switches and drive electromotors стеклоподъемников
   Check of serviceability of functioning of the operating switch and electromotors of adjustment of door rear-view mirrors
   Salonnye fixtures - replacement of lamps, check of serviceability of functioning
   Replacement of lamps and check of serviceability of functioning of external lighting devices
   Removal, check of serviceability of functioning and installation of the breaker of indexes of turns/alarm systems
   Removal, installation and adjustment of block headlights
   Safety pillows - the general information and safety measures
   Switching-off SRS
   Reading of codes of malfunction DTC
   Removal and installation of the module of a driver's pillow of safety
   Removal, installation and adjustment of a contact cable drum of the module of a driver's pillow of safety
   Removal and installation of the diagnostic module of pillows of safety (ADU)
Control кузовные the sizes
Schemes of electric connections




Kia Sportage>> Onboard electric equipment>> Removal, installation and adjustment of a contact cable drum of the module of a driver's pillow of safety

Removal, installation and adjustment of a contact cable drum of the module of a driver's pillow of safety

The combined contact socket of electroconducting of a cable drum is not subject to dismantle and in an individual order does not vary.

Removal and installation

Before to start procedure performance, familiarise with resulted in Section of the Pillow of safety - the general information and safety measures the list of security measures!


 PERFORMANCE ORDER

    Details of installation of a cable drum are shown on an illustration of the Detail of installation of the module of a driver's face-to-face pillow of safety. Establish forward wheels in rectilinear position. Make sure that forward wheels of the car are resulted in rectilinear position. Remove the module of a driver's face-to-face pillow of safety (see Has undressed Removal and installation of the module of a driver's pillow of safety). Release a nut of fastening of a steering wheel. Mark position of a wheel concerning a steering shaft. By means of a special stripper dismantle a steering wheel. Turn out three fixing screws and dismantle a contact cable drum together with combined подрулевым the switch. Installation is made upside-down, - before definitive installation of a steering wheel and the module of a pillow of safety do not forget to adjust a cable drum.

Adjustment

At adjustment of a contact cable drum the special pin which is delivered complete with new подрулевым the switch is used, - at installation of the original switch it is necessary to prepare replacement to an adjusting pin.


 PERFORMANCE ORDER

    Temporarily establish a steering wheel and deduce forward wheels of the car in rectilinear position. Remove a wheel. Against the stop develop a cable drum clockwise.
    Return a drum back on 2.75 a turn, - стрелочные indexes on a plate of a drum and its casing should be combined.
    Establish a steering wheel, - track correctness of combination of the landing labels put in the course of dismantle.