Kia Sportage>>
Body>>
The external equipment and кузовные elements
The external equipment and кузовные элеиенты
Removal, installation and adjustment of components of devices of clearing and windscreen washing
The scheme of the organisation of clearing of a windscreen
Replacement of brushes
|
|
Take away the lever to subject replacement of a brush from a windscreen.
|
|
Wring out a lock uvula in the lock of a brush and remove last from a hook on the lever end.
|
At landing of a brush to the lever track reliability защелкивания the lock.
|
|
Removal
Levers of screen wipers with brushes
|
|
Make sure that screen wipers are in "parking" position, - in case of need include ignition, start and again stop screen wipers.
|
|
Dismantle a protective cap, release a fixing nut and remove the lever from a spindle приводной draughts.
|
|
|
The electromotor of a drive of screen wipers
|
|
|
|
Open a cowl and turn out four bolts of fastening of the electromotor of a drive of screen wipers.
|
Disconnect electroconducting.
|
|
Separate assemblage of the electromotor from the panel обтекателя and, having hooked a screw-driver, separate from it draught of a drive of screen wipers.
|
Remove the electromotor.
|
|
Draughts of a drive of screen wipers
|
|
Turn out six fixing screws, release two clamps and remove a lattice (see Has undressed Removal and lattice installation обтекателя).
Give a fixing bolt and a nut and, operating on the left side of the car, remove assemblage of draughts of a drive of screen wipers from the panel обтекателя.
Manually check up rotation freedom шарнирных assemblage joints, in case of need add greasings.
|
|
The tank and the pump of giving of a washing liquid
|
|
Disconnect a negative wire from the battery.
Disconnect electroconducting of the pump and a hose of giving of a liquid.
|
|
Turn out fixing bolts and take the tank with the pump established on it from an impellent compartment.
|
|
|
Installation
|
|
|
|
Installation is made upside-down. Track correctness of a condition of the electromotor at connection to it приводной draughts, - brushes after installation should appear in "parking" position. All fixture tighten with demanded effort.
|
|
|
Adjustment snuffled givings of a washing liquid
|
|
|
|
Adjustment is made by поворачивания a jet of a nozzle by the needle entered its working aperture, - the stream should get to a correct place on glass.
|
|
|
In avoidance обламывания in a jet, it it is necessary to "release" needles preliminary, heating in a lighter flame. |
|
|