Kia Sportage>>
Suspension bracket and steering>>
Suspension bracket geometry>>
Check and adjustment of corners of installation of forward wheels
Check and adjustment of corners of installation of forward wheels
Make sure of performance of all necessary conditions (the Section suspension bracket Geometry see).
Disorder and выбег
Check
|
|
Check of geometrical parametres of a suspension bracket should be made at the special stand in the conditions of a car-care centre workshop. |
|
|
Tyre out the car forward wheels on rotary circles of in special way equipped stand.
Remove ступичные муфты a free wheeling.
Connect a measuring instrument and make necessary measurements. Compare results of measurement to requirements of Specifications of the Head the Suspension bracket and a steering, in case of need make corresponding updatings.
|
|
Adjustment
Disorder adjustment is made by simultaneous поворачивания in one direction (to from a plane of symmetry of the car, or outside) and on an identical corner эксцентриковых шпиндельных fastening bolts to a frame of the top levers of a suspension bracket. Each division of the scale put on a flange of a head of a bolt corresponds to disorder change on 0.4 , - as a basic label the vertical risks put on a surface of basic arms of levers are used.
The size выбега is corrected by simultaneous поворачивания the same bolts, but in opposite directions (one to a plane of symmetry of the car, the second - outside). Thus the adjustment step makes 0.55 on one division of a scale.
Convergence
Check
|
|
Tyre out the car on an equal horizontal platform with a firm covering and result forward wheels in rectilinear position.
|
|
By means of a measuring bar define size of convergence of wheels. Compare result of measurement to requirements of Specifications of the Head the Suspension bracket and a steering, in case of need make corresponding updating.
|
|
|
Adjustment
|
|
Release counternuts of tips of both steering draughts.
|
|
Adjust convergence of forward wheels by поворачивания on an identical corner and in one direction of both tips.
|
Do not forget to tighten a counternut with demanded effort (88 118 Nanometers).
|
|