KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
   The general information
   Search of malfunctions - the general information
   Reading of codes DTC, clearing of memory of the processor
   Checks and adjustments of components of control system АТ
   Checks and adjustments of a mehaniko-hydraulic part
   Check and adjustment приводного cable АТ
   Removal and installation of the lever of selector AT
   Removal and installation АТ
Transmissionnaja line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections


Access exclusive content and early releases on Soap2day.


Kia Sportage>> Automatic transmission>> Removal and installation АТ

Removal and installation АТ

 PERFORMANCE ORDER

    Disconnect a negative wire from the battery. Merge ATF (Current leaving and service see the Head), - do not forget to screw into place a drain stopper. Operating through an impellent compartment, disconnect from transmission приводной a cable. Turn out two fixing screws and remove back section of a console ware box. Turn out three fixing screws and remove forward section of a console ware box. Translate in neutral position and remove the lever of switching of modes of a distributing box (the line see Head Transmissionnaja). Remove selector AT lever (see Has undressed Removal and installation of the lever of selector AT). Having marked landing position of connecting flanges, release fastening bolts to a distributing box forward and back карданных shaft. Disconnect tubes of a path of cooling ATF from a radiator of system of cooling and transmission.
A — From outside a radiator
In — From outside АТ
1 — Hose ATF
2 — Tube ATF
    Disconnect electroconducting from VSS and gauges-switches of fires of a backing and the indicator 4WD.
Socket of electroconducting VSS (1).
Sockets of electroconducting of gauges-switches of the indicator of activation of a mode 4WD (1) and fires of a backing (2).
    Remove a starter (see the Head of System of an electric equipment of the engine). Turn out bolts of fastening of a distributing box. Turn out bolts of fastening АТ to the engine. Поддомкратьте трансмиссионным a jack a basic cross-section beam. Turn out bolts of fastening of a cross-section beam, then lower and трансмиссионную assemblage and take it from under the car. Separate from АТ a distributing box and a basic beam. Carefully smooth out interfaced surfaces, prepare fresh landing hermetic. Installation is made upside-down, track observance of requirements of Specifications of the Head Automatic transmission to efforts of a tightening of carving fixture. At connection to a distributing box карданных shaft track correctness of combination of the landing labels put in the course of dismantle.