KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
   The general information
   Search of malfunctions - the general information
   Reading of codes DTC, clearing of memory of the processor
   Checks and adjustments of components of control system АТ
   Checks and adjustments of a mehaniko-hydraulic part
   Check and adjustment приводного cable АТ
   Removal and installation of the lever of selector AT
   Removal and installation АТ
Transmissionnaja line
Brake system
Suspension bracket and steering
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections

Kia Sportage>> Automatic transmission>> Removal and installation of the lever of selector AT

Removal and installation of the lever of selector AT

Design and details of installation of the lever of selector AT

1 — the Handle
2 — the Casing
3 — the Display panel

4 — Shpindelnyj a bolt
5 — the Directing plate
6 — the Lever


    Disconnect a negative wire from the battery. Remove back and forward sections of a console ware box (the Body see the Head).
    Translate selector AT lever in position Р, then release fixing nuts.
    Take шплинт and separate from the lever (1) selector rod (2).
    Disconnect electroconducting of the indicator of positions and the switch of mode HOLD. Turn out the fixing screw and remove from the lever the handle and a casing.
1 — the Handle
2 — the Casing
    Remove the display panel (1).
    Release a fixing nut, take шпиндельный a bolt (1) and separate the lever from a directing plate.
    Grease the specified elements of a directing plate.
    Grease распорную the plug, fill the lever on the regular place in directing plate and fix it шпиндельным a bolt, having tightened a nut of the last with demanded effort (11.7 16.7 Nanometers).
    The further installation is made in an order, the return to an order of dismantle of components, - the effort of a tightening of the screw of fastening of the handle of the lever makes 2.0 3.0 Nanometers, nuts of a directing plate of lever assemblage, - 17.6 26.5 Nanometers. Do not forget to restore initial connection of electroconducting.