KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
Five-step manual box of a gear change
Automatic transmission
   The general information
   Search of malfunctions - the general information
   Reading of codes DTC, clearing of memory of the processor
   Checks and adjustments of components of control system АТ
   Checks and adjustments of a mehaniko-hydraulic part
   Check and adjustment приводного cable АТ
   Removal and installation of the lever of selector AT
   Removal and installation АТ
Transmissionnaja line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections

Kia Sportage>> Automatic transmission>> Reading of codes DTC, clearing of memory of the processor

Reading of codes DTC, clearing of memory of the processor

Reading of codes

One of the functions which are carried out by the module of management АТ (TCM), the continuous problem diagnostics of components of a control system of transmission (information gauges, actuation mechanisms and actually TCM) is. In case of revealing of malfunction the management module fixes in the memory a 5-unit diagnostic code (DTC), adhered to corresponding contour of a control system. The list of the most typical codes is resulted in Specifications of the Head Automatic transmission.

For reading written down in memory of processor DTC special scanner Hi-Scan Pro (K2CA 089 HSP), connected to the equipped diagnostic socket located in an impellent compartment folding cover (Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases see) is used.

 PERFORMANCE ORDER

    Connect the scanner, include ignition and, operating according to instructions of manufacturers of the device, poll memory of processor TCM, - at presence in memory of codes of malfunctions (DTC), make corresponding regenerative procedures.

At absence near at hand the scanner reading of codes can be made by means of control lamp HOLD: at the switched off ignition close the plug n on the grounding plug (s) DLC, then turn a key in position ON, - the table of codes of conformity and the diagramme of their principle высвечивания are resulted in Specifications of the Head Automatic transmission.

    In summary make clearing of memory TCM, then repeat procedure of reading and make sure that memory of the processor is empty.

Clearing of memory of the processor

Clearing of memory TCM is made by means of the scanner (operate according to instructions of manufacturers of the device). Alternatively, it is possible to clear memory by plug short circuit j on the grounding plug (s) DLC at the included ignition.

 PERFORMANCE ORDER

    In summary make sure that any DTC have not been brought in memory of the module repeatedly.