KIA Sportazh - Kia Sportage
Controls and operation receptions
Current leaving and service
The engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of the engine/decrease of toxicity of the fulfilled gases and release of the fulfilled gases
Systems of an electric equipment of the engine
   System of ignition of the petrol engine
      The general information, security measures
      Checks of a control system by ignition
      Check of a corner of an advancing of ignition
      Check of coils of ignition
      Check of condition ВВ of electroconducting
      Check of the gauge of a detonation
      Replacement of coils of ignition
      Spark plugs - the general information
      Removal and installation of the gauge of position of a camshaft (CMP)
      Removal and installation of the gauge of position of a cranked shaft (CKP)
      Removal and installation of the gauge of a detonation (KS)
   System of simplification of cold start of the diesel engine
   Charge and start systems
Five-step manual box of a gear change
Automatic transmission
Transmissionnaja line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control кузовные the sizes
Schemes of electric connections



Kia Sportage>> Systems of an electric equipment of the engine>> System of ignition of the petrol engine>> Check of coils of ignition

Check of coils of ignition

Ignition coils are located under a service cover from the top party of the power unit under a sleeve of an inlet air path of the engine.

1 — ignition Coils
2 — the Inlet air line
3 — the Service cover

Pressure check

 PERFORMANCE ORDER

  1. Make sure that ignition is switched off.
  2. Remove a service cover and disunite a contact socket of the coil of ignition.
  1. Include ignition and measure pressure on plugs of white-red wires of a contact socket of the coil, - demanded value makes an order 12 Century
  1. If pressure is absent, check up a condition of the main safety lock, the switch of ignition and connecting electroconducting of a corresponding contour.
  2. The faulty coil is subject to replacement.

Resistance check

Remember that in each coil it is organised on two primary and on two secondary windings which should be checked in an individual order.


 PERFORMANCE ORDER

  1. Connect an ohmmeter to positive (+) to the plug of a contact socket of the coil, then, serially connecting the second wire of a measuring instrument to negative (-) to socket plugs, measure resistance of primary windings of bobbin assemblage, - demanded value makes 0.45 0.55 Ohm at 20 With.
  1. Operating in a similar manner, measure resistance of secondary windings of the coil, - demanded value makes 13 15 clod at 20 C.
  1. At failure of any of windings bobbin assemblage is subject to replacement (the Section Replacement of coils of ignition see).